RacerMate Velotron

Compatibility with Peaksware Software:

  • Export a .txt file from the RacerMate software (see below for how to do this).

    • Once you have located the .txt file, you can either...

      • Upload that file to your TrainingPeaks.com online account, as explained here
      • Or, you can drag-and-drop import it to WKO+

Exporting a File from the RacerMate Software:


  • RacerMate Coaching Software 
  • CompuTrainer PC1 Challenge or 3D Software 
  • Access to previous race performance files

In order to import your Velotron session into TrainingPeaks or WKO+ you will need to have the CompuTrainer Coaching Software (CS). To obtain the CompuTrainer Coaching Software, or for further help with the it, please contact RacerMate at:


Velotron File Management: This whole procedure relies on proper file management with the Velotron software. After each ride, a rider performance file is created. This file will be overwritten if you do not rename it or save it immediately after the ride. For more information on this procedure please refer to the Velotron user/owner manuals. They can also be found online at:


Note: It is recommended that you rename the file with the date (and possibly time).



1) Specify comma delimited for the export options.

The comma delimited field should show a check mark next to it:

Menu: File/Export/Comma Delimited? 


2) Select the fields to be exported and the toss option (this will be saved for future exports)

Menu: File/Export/Export Option. 

The bold items must be included. If left out, the file will upload but an error will be produced when it is graphed. It is recommended including the non-bold items as there may be a time in the future that TrainingPeaks will utilize that data. By default, all items are exported.

Toss option: This option tells the export function how many lines to discard (toss). If the value is set to 0 then it will keep every line. Of course, a 1 hr Velotron 3d file will wind up being about 8.5MB and pretty much impossible to upload to TrainingPeaks. The best compromise is a toss value of 100. This results in a sampling rate of about 1 data point per 3 seconds: NOTE: Using a toss value of lower than 100 may cause the upload to TrainingPeaks to time out. Here is a quick reference table for 3dp rider performance file-size with a toss value of 100.


3) Exporting the file

Menu: File/Export/Short 

After setting the options, you will need to then go back into the CS and do the actual export. The CS will then ask you to identify the rider performance file you would like to export. After this, depending on the speed of your machine, the dialog box will appear and confirm the export and location of the exported file.

By default the exported file will be put into the same directory as the rider performance file you chose and named the same (with the exception of a .txt extension). You now have a file that can be directly imported into TrainingPeaks.com through the workout Quick View, or imported to WKO+.

Was this article helpful?
0 out of 0 found this helpful